6 Cylinder Replacement Parts



Placeholder image

EA-21000 Upgrade Kit $1400.65


Upgrade from your GEN 1 Electroair electronic ignition system with the latest controller design. This controller incorporates the MAP Sensor and the ignition controller into a smaller package which allows for easier installation. Contact Electroair with any questions.

For Distributor Information click here.


Placeholder image

EA-9000 Lycoming Crank Shaft Trigger Wheel Kit $995.00


EIS Controller & Wire Harness

The EA-9000 Crank Shaft Trigger Wheel kit mounts on the bare spot of the crank shaft just behind the propeller flange. (Click here for typical install pictures). NOTE: Specify whether or not this is an O/IO-540 or AEIO-540 engine.

For Distributor Information click here.


Placeholder image

EA-10000 Mag Timing Housing Continental Engine Applications $1,885.00


EIS Controller & Wire Harness

The EA-10000 replaces the magneto found on most Continental engines. This unit provides the EA-7000 Controller with the engine position and RPM information needed to drive the electronic ignition system. Installation is very easy - much like a magneto. Engine to TDC on #1 cylinder, lock-pin in the MTH and then drop it in the mag hole. Tighten the hold down clamps and pull the lock pin. That's it!

For Distributor Information click here.


Placeholder image

EA-12000 Mag Timing Housing $1,885.00


The EA-12000 replaces the impulse-coupled magneto found on most Lycoming engines. This unit provides the EA-7000 Controller with the engine position and RPM information needed to drive the electronic ignition system. Installation is very easy - much like a magneto. Engine to TDC on #1 cylinder, lock-pin in the MTH and then drop it in the mag hole. Tighten the hold down clamps and pull the lock pin. That's it!

For Distributor Information click here.


Placeholder image

EA-11000 Crank Shaft Trigger Wheel Kit $995.00


The EA-11000 Crank Shaft Trigger Wheel kit mounts on the bare spot of the crank shaft just behind the propeller flange. (Click here for typical install pictures). NOTE: Minimum clearance of 0.650" between the front of the engine case and propeller studs is REQUIRED. Please check this dimension before starting installation ordering the kit.

For Distributor Information click here.


Placeholder image

EA-8000 6cyl Coil Pack | $992.25


The EA-8000 is the 6cyl Coil Pack used in the EIS-61000 Electronic Ignition System. This unit can be used in either a 12V or 24V application.

For Distributor Information click here.


Placeholder image

EA-7000TP 6cyl Electronic Ignition Kit $1,385.00


EIS Controller & Wire Harness

The EA-6000/EA-6000TP is the brains of the Electroair Electronic Ignition System. This replacement unit includes the controller and replacement wire harness necessary for Aircraft with 6cyl engines. This unit can be used in either a 12V or 24V application.

For Distributor Information click here.